Tornado ITSF rubber handle bar
slide 2 of 3
€5.75*
Currently not available, please sign up to get notified
Product number: 7091.2
safe shopping
Selected variant:Color: Black
New Tornado ITSF handle made from plastic with a rubber coating
This plastic handle bar with big diameter is used on every new Tornado foosball table. Compared to the old wooden Tornado handle bar, this one is more catchy, based on new rubber coating. The shape of the handle bar is exactly the same of the old one. To install the handle bar, you need a special bolt, which is responsible for the tight hub.
Measure of the Tornado ITSF handle:
Length = 124 mm
Ø = 35 mm
Weight = 86 g
Properties "Tornado ITSF rubber handle bar"
| Color: | Black |
|---|
7091
We also recommend
slide 1 to 3 of 3
Notify me
Tornado Roll pin
Original roll pin for fastening of handles and figures The original Dynamo-Valley roll pin has to be hammered into the figure or the handle befor the fastening. The chequered front side is cause of the good fit. You have to use a hammer and a special pin punch to insert or to take the roll pin out. Measure of the Tornado roll pin: Length = 32 mm Ø = 4,5 mm Weight = 3 g
€0.40*
Notify me
Tornado figure
Official Tornado tournament foosball figure The fancy and distinctive design is feature of the Tornado figure. You can easily play Tic Tac between the figures due to the wide side profiles. The figures are tightened with a special bolt, so that the figures cannot shake around. Measure of the Tornado Figure: Height= 107 mm Middle of rod till foot = 72 mm Ø for the rod = 16 mm Weight= 66 g You will find the adapted screws here.
€5.75*
Notify me
Tornado handle bar
The official Tornado foosball handle made from wood - for all Tornado models Compared to other wooden handle bars, this one is not coated, this one is open-pored, so that the hand perspiration can be absorbed. The Tornado handle as well as the Tornado figure is bolted onto the bar, which ensures optimal grip. Measure: Length = 125 mm Ø = 35 mm Weight = 55 g
€4.80*
Recently viewed
slide 1 of 1
Notify me
Leonhart ending cap
Ending cap by Leonhart The ending cap has to be put in the end of the bar and serves as visual ending as well as protection against injuries. This ending cap is used on all Leonhart- and Löwen-models. Measure: Ø = 21 mm Height = 24 mm Weigh = 2,6 g
€0.50*